The windshield wiper/washer lever is on the right side of the steering column.
Move the lever to one of the following positions: HI: Use for fast wipes.
LO: Use for slow wipes.
INT (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then
turn the INT band up for more frequent
wipes or down for less frequent wipes.
OFF: Use to turn the wipers off.
(Mist): For a single wipe, briefly
move the wiper lever down. For several wipes, hold the wiper lever down.
Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Replace damaged wiper blades. See Wiper Blade Replacement on page 10-24.
Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down.
If the ignition is turned to LOCK/ OFF while the wipers are on LO, HI, or INT, they will immediately stop.
If the windshield wiper lever is then moved to OFF before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield.
If the ignition is turned to LOCK/ OFF while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield.
Pull the windshield wiper lever toward you to spray windshield washer fluid and activate the wipers.
The wipers will continue until the lever is released or the maximum wash time is reached.
When the windshield wiper lever is released, additional wipes may occur depending on how long the windshield washer had been activated. See Washer Fluid on page 10-19 for information on filling the windshield washer fluid reservoir.
In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision.
Passenger Sensing System
The vehicle has a passenger sensing system for the front outboard passenger position. The passenger airbag status indicator will light on the center display when the vehicle is started. United States Canada The words ON and OFF, or the symbol for on and off, will be visible during the ...
To lock or unlock the doors from outside the vehicle: Use the key in the driver door to lock and unlock the door. Press or on the Remote Keyless Entry (RKE) transmitter, if equipped, to lock and unlock the doors. See Remote Keyless Entry (RKE) System Operation on page 2-3. ...
Connector Retaining Tab Connector Release Headlamp Bulb To replace a headlamp bulb: Open the hood. See Hood on page 10-5. Remove the connector retaining tab (1). Disconnect the wiring harness connector from the bulb (3) by pressing the connector release (2) and pulling strai ...