Chevrolet Spark manuals

Chevrolet Spark Owners Manual: High/Low-Beam Headlamp

Chevrolet Spark. High/Low-Beam Headlamp


  1. Connector Retaining Tab
  2. Connector Release
  3. Headlamp Bulb

To replace a headlamp bulb:

  1. Open the hood. See Hood on page 10-5.
  2. Remove the connector retaining tab (1).
  3. Disconnect the wiring harness connector from the bulb (3) by pressing the connector release (2) and pulling straight back.
  4. Remove the bulb (3) from the headlamp assembly by turning counterclockwise and pulling straight back.
  5. Install the new bulb in the headlamp assembly by turning clockwise.
  6. Install the wiring harness connector to the bulb. Be sure the connector release (2) locks into place.
  7. Install the connector retaining tab (1).
Headlamps, Front Turn Signal and Parking Lamps
...

Front Turn Signal/Parking Lamps
To replace a front turn signal bulb: Open the hood. See Hood on page 10-5. Turn the bulb socket counterclockwise and pull it out of the lamp housing. Pull the bulb straight out of the ...

Other materials:

Vehicle Load Limits
It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo, and all nonfactory-installed options. Two labels on the vehicle show how much weight it may properly carry: the Tire and Loadi ...

Fuel Gauge
The fuel gauge indicates about how much fuel is left when the ignition is turned to ON/RUN. When the tank nears empty, the low fuel warning light will come on. There is still a little fuel left, but the vehicle's fuel tank should be filled soon. See Low Fuel Warning Light on page 5-20 ...

Introduction
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET, the CHEVROLET Emblem, and SPARK are trademarks and/or service marks of General Motors LLC, its subsidiaries, affiliates, or li ...

© 2017-2021 Copyright www.ad-tech.site