Use only lukewarm or cold water, a soft cloth, and a car washing soap to clean exterior lamps, lenses, emblems, decals and stripes. Follow instructions under "Washing the Vehicle" previously in this section.
Lamp covers are made of plastic, and some have a UV protective coating. Do not clean or wipe them when dry.
Do not use any of the following on lamp covers:
Failure to clean lamps properly can cause damage to the lamp cover that would not be covered by the vehicle warranty.
Using wax on low gloss black finish stripes can increase the gloss level and create a non-uniform finish. Clean low gloss stripes with soap and water only.
Clear debris from the air intakes, between the hood and windshield when washing the vehicle.
Automatic Headlamp System
When it is dark enough outside and the exterior lamp control is in the automatic position, the headlamps come on automatically. See Exterior Lamp Controls on page 6-1. The vehicle has a light sensor on top of the instrument panel. Make sure it is not covered, or the headlamps will be on w ...
The ignition switch has four different positions. The uplevel key must be fully extended to start the vehicle. To shift out of P (Park), the ignition must be in ON/RUN and the regular brake pedal applied. 1 (STOPPING THE ENGINE/LOCK/ OFF): When the vehicle is stopped, turn the ignition sw ...
Tire Pressure Monitor System
The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. The TPMS sensors monitor the air pressure in your tires and transmit tire pressure readings to a receiver located in the vehicle. Each tire, including the spare (if provided), should be check ...